You run OSX in 32 bit mode keeping the 3 key pressed during bootĪfter these changes the subsequent call to SNX (configured as described above) was able to associate the proper IP address (that in my configuration was 192.168.1.33, last number changes from connection to connection) to the en7 interface created by SNX and so I've a valid IP address for the router on the 192.168.2 network and one for the office on the 192.168.1 network.The subnet mask of the local IP address is now 255.255.0.0.The DHCP server now gives addresses that start with 192.168.2 instead of the old 192.168.1. I was able to run the client making some modification to the wireless router configuration: Problem is that at this point it seems to connect (because IP address are correct and also because if I provide a wrong password it give me the correct unsuccesful logon message) but if I do a ifconfig I see that the interface created from Checkpoint do not have an IP address and also if I try to add one using ifconfig I'm not able to ping any machine on the remote network ifconfig en7Īny idea about I can assign a proper IP address to the interface so that I can use the remote network? snxrc profile, after that snx is able to connect like so snx Until now the most interesting result were installing the SNX client from CheckPoint and then creating a.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |